Cummins — 3666003

Coolant Thermostat C Series Page 8-12 Section 8 - Cooling System - Group 08 Debris in the cooling system can cause damage to the engine. CAUTION Remove the thermostat gasket and clean the gasket surface. CAUTION Do not shim the thermostats beyond the top of the block. Measure the distance from the thermostat flange to the top of the block surface of each thermostat to determine the proper shim(s) to use. NOTE: The service shims included are 0.25 mm [0.010 in], 0.50 mm [0.020 in], 0.75 mm [0.030 in], and 1 mm [0.040 in]. Select the appropriate combination that will bring the thermostat height as close to the top of the block as possible. NOTE:

Any combination of shims can be used, but stacking is limited to a maximum of two shims per bore. Remove each thermostat and insert the selected shims into each bore, making sure each shim is seated properly in the bore. Inspect for Reuse Inspect the thermostats for damage. Make sure both thermostats are clean and free from corrosion.