C Series Coolant Thermostat Housing Section 8 - Cooling System - Group 08 Page 8-15 Finishing Steps Batteries can emit explosive gases. To avoid personal injury, always ventilate the compartment before servicing the batteries. To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING Install the alternator. Refer to Procedure 013-001. Install the drive belt. Refer to Procedure 008-002. Install and tighten the battery's electrical connections. NOTE: During filling, air must be vented from the engine's coolant passages. Open the engine vent petcock, if equipped. Make sure to open the petcock on the aftercooler for aftercooled engines.
The system must be filled slowly to prevent air locks. Wait 2 to 3 minutes to allow air to be vented; then add coolant to bring the level to the bottom of the radiator filler neck. Fill the cooling system. Refer to Procedure 008-018. Operate the engine to normal operating temperature and check for leaks. Coolant Thermostat Housing (008-014) Remove Remove the thermostat housing and and belt tensioner assembly. Refer to Procedure 008-013. Remove the thermostats.