Cummins — 3666003

Cooling System C Series Page 8-28 Section 8 - Cooling System - Group 08 Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. WARNING Operate the engine for 5 minutes with the coolant temperature above 80°C [176°F]. Shut the engine OFF, and drain the cooling system. NOTE: Make sure to vent the engine and aftercooler for complete filling. NOTE: Do not install the radiator cap or the new coolant filter. Fill the cooling system with clean, good, and quality water. Operate the engine for 5 minutes with the coolant temperature above 80°C [176°F]. Shut the engine OFF, and drain the cooling system. NOTE:

If the water being drained is still dirty, the system must be flushed again until the water comes out clean. Fill Marine Applications QSC8.3 and QSL9 Engines with Heat Exchangers The system has a design fill rate of 19 liters per minute [5 gallons per minute]. Marine engines must be vented at the coolant outlet housing, and at the rear of the expansion tank during filling. Fill the cooling system with fully formulated coolant or a 50/50 mixture of recommended antifreeze and clean, good quality water, as outlined in the Owners Manual. Install the pressure cap. Operate the engine to 50°C [122°F], and check for coolant leaks.