C Series Cooling System Section 8 - Cooling System - Group 08 Page 8-27 The system has a design fill rate of 19 liters per minute [5 gallon per minute]. Marine engines must be vented at the coolant outlet housing and at the rear of the expansion tank during filling. Fill the cooling system with clean, good quality water. Operate the engine for 5 minutes with the coolant temperature above 85°C [185°F]. Shut the engine OFF, allow to cool to 50°C [122°F], and drain the cooling system. If the water being drained is still dirty, the system must be flushed again until the water comes out clean. All Applications Except Marine CAUTION The system must be filled properly to prevent air locks.
During filling, air must be purged from the engine coolant passages. Be sure to open the petcock on the aftercooler for aftercooled engines. Wait 2 to 3 minutes to allow the air to be vented; then add coolant mixture to bring the level to the top. NOTE: Adequate venting is provided for a fill rate of 19 liters [5 gal] per minute. Do not install the radiator cap. The engine is to be operated without the cap for this process. CAUTION Fill the system with a mixture of sodium carbonate and water (or a commercially available equivalent). NOTE: Use 0.5 kg [1 lb] of sodium carbonate for every 23 liters [6 gal] of water.