Cummins — 3666003

C Series Fan Shroud Assembly Section 8 - Cooling System - Group 08 Page 8-39 Install Install the fan hub and four capscrews. Tighten the capscrews. Torque Value: 24 N•m [ 212 in-lb ] Finishing Steps Install the fan pulley. Refer to Procedure 008-030 (Fan Drive Idler Pulley Assembly) in Section 8. Install the drive belt. Refer to Procedure 008-002 (Drive Belt, Cooling Fan) in Section 8. Operate the engine and check for proper operation.

Fan Shroud Assembly (008-038) Initial Check CAUTION The fan shroud must be installed correctly, be in good condition, and the shroud-to-fan clearance must be within the manufacturer's specifications for proper airflow through the radiator to provide adequate engine cooling. Inspect the fan shroud for proper fan clearance, cracks, air leaks, or damage. Replace, if necessary. Refer to the equipment manufacturer's service manual for instructions. Cummins Inc. recommends fan clearance be 5.08 to 10.16 cm [2 to 4 in] from the radiator core. Refer to the equipment manufacturer's service manual for alternative positions.