Cummins — 3666003

Water Pump C Series Page 8-50 Section 8 - Cooling System - Group 08 Finishing Steps Install the inlet and outlet hose to the pump. Open the sea water inlet valve and check for leaks. If you have a wet exhaust system, start the engine and check for water flow from the exhaust. Also, check the sea water pump and plumbing for leaks. Supplemental Coolant Additive (SCA) (008-060) Initial Check Additive Concentration - Checking The cooling system must contain the proper coolant additive units to provide the best chemical protection. Refer to the Operation and Maintenance Manual, C Series Engines, Bulletin No. 3666183. DCA4 Test Kit: Use only DCA4 coolant test kit, Fleetguard® Part No.

CC-2626, to measure the coolant additive concentration in the cooling system. Water Pump (008-062) Preparatory Steps WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. Drain the coolant. Refer to Procedure 008-018.