C Series Water Pump Section 8 - Cooling System - Group 08 Page 8-53 Use Fleetguard® refractometer, Part Number CC-2800, to check the antifreeze level of the coolant. NOTE: Ethylene-glycol-type antifreeze concentration levels exceeding 70 percent will lessen the freezing point protection and will contribute to water pump seal leakage. If the antifreeze concentration is above 60 percent, drain all the coolant and add makeup water to bring the antifreeze concentration between a minimum of 40 percent to a maximum of 60 percent.
Replace the coolant filter and add new coolant inhibitor to the recommended levels as outlined in the Operation and Maintenance Manual, C Series Engines, Bulletin Number 3666183. CAUTION If the coolant leakage is observed as a steady stream upon start-up, stop the engine immediately and replace the water pump. Operate the engine at high idle for 15 minutes with the proper inhibitor and antifreeze levels, and inspect the water pump for leakage. If the coolant is leaking after the above inspections, replace the water pump.