Cummins — 3666003

Water Pump C Series Page 8-52 Section 8 - Cooling System - Group 08 The water pump pulls coolant from the bottom of the radiator and pumps it through the engine back to the top of the radiator for cooling. A worn or malfunctioning water pump will not produce the flow required to prevent the engine from running hot. Make sure to inspect the other possibilities indicated in the Troubleshooting Logic Chart before inspecting the flow or replacing the water pump. Check the water pump seal weep hole. The water pump seal design requires a coolant film for lubrication and cooling. Therefore, it is normal to observe a minor chemical buildup or streaking at the weep hole. NOTE:

A streak or chemical buildup at the weep hole is not justification for water pump replacement. Use the following guidelines to determine if water pump replacement is necessary: Make sure the weep hole is open. NOTE: A small screwdriver or a similar tool can be used to remove any debris. If no leakage is observed from the weep hole under operating conditions, do not replace the water pump. If coolant is seen dripping from the weep hole: Use Fleetguard® coolant test kit, Part Number CC-2626, to check the coolant inhibitor level, and adjust the inhibitor level according to the test kit chart. NOTE:

Supplemental coolant additive concentrations exceeding 2 units per gallon will cause water pump seal leakage.