Cummins — 3666003

C Series Sea Water System Diagnostics Section 8 - Cooling System - Group 08 Page 8-63 Record the sea water inlet restriction from low idle to rated speed at 500 rpm increments. This test can be conducted while the vessel is at the dock and not in gear or underway. Refer to Procedure 018-018 for Marine engine specifications. If the sea water inlet restriction is above specification, the source of the restriction must be found. Troubleshooting and repair of excessive sea water restriction is a boat manufacturer or boat owner responsibility. Refer to the vessel's OEM service manual.

If the inlet restriction is within the specification and the complaint can not be verified at the dock, the test must be repeated underway. If the sea water inlet restriction readings fluctuate during the test, inspect the sea water supply for leaks or air intrusion. Troubleshooting and repair for sea water aeration is not covered under Cummins warranty. It is possible that aeration (gauge fluctuation) will only occur while the vessel is underway due to the introduction of air. Refer to the vessel's OEM service manual.