C Series Sea Water Hoses Section 8 - Cooling System - Group 08 Page 8-67 Install the sea water test tool with a temperature probe between the outlet side of the heat exchanger and the exhaust elbow (1). Operate the engine at rated rpm and load and record the temperature. Install the temperature probe in the outlet side of the aftercooler (1). Operate the engine at the rated rpm and load and record the temperature. If the temperature difference between the aftercooler outlet and the engine heat exchanger outlet is greater than 20° C [40° F], check the sea water pump for water flow problems. Refer to Procedure 008-057.
If the sea water temperature difference is less than 3°C [5°F], check the heat exchanger for possible plating to the heat exchanger core. Excessive plating or coating to the inside or outside of the cooling tubes will affect the efficiency of the heat exchanger. Sea Water Hoses (008-104) Inspect Start engine, and inspect all hoses and connections for deterioration or leaks. Replace damaged hoses and clamps, if necessary.