Cummins — 3666003

Sea Water System Diagnostics C Series Page 8-66 Section 8 - Cooling System - Group 08 If the pressure drop in the gear oil cooler is within specification, test the pressure drop across the engine heat exchanger. Fabricate a sea water test tool by using a 44 mm [1 3/4 in] pipe with a fitting in the center to connect a pressure gauge. Install the fabricated test tool between the outlet side of the heat exchanger and the exhaust elbow. Check the pressure drop across the heat exchanger. If the pressure drop is greater than the maximum specification, check for blockage in the heat exchanger. Clean or replace if necessary. Refer to Procedure 018-018 for Marine engine specifications.

If the pressure drop across the heat exchanger is within specification, determine the pressure drop across the exhaust elbow (diffuser). This is done by subtracting the heat exchanger outlet pressure from the sea water pump outlet pressure. If this pressure exceeds the maximum specification, check for blockage in the exhaust elbow (diffuser) and exhaust system of the vessel. Clean or replace if necessary. Refer to Procedure 018-018 for Marine engine specifications. Temperature Differential Test Fabricate a sea water test tool by using a [1 3/4 in] pipe with a fitting in the center to connect a temperature probe.