C Series Sea Water System Diagnostics Section 8 - Cooling System - Group 08 Page 8-65 Pressure Differential Test Check the sea water pressure at the inlet side of the aftercooler at the rated rpm. Record the reading. If the pressure drop between the sea water pump outlet and the aftercooler inlet exceeds the maximum specification, check or replace fuel cooler plumbing as necessary. Refer to Procedure 018-018 for Marine engine specifications. If the pressure drop is within specification, check the sea water pressure at the discharge side of the aftercooler outlet. Record the reading.
If the pressure drop between the inlet side of the aftercooler exceeds the maximum, check for blockage in the aftercooler. Clean or replace if necessary. Refer to Procedure 018-018 for Marine engine specifications. If the pressure drop between the inlet side of the aftercooler and the outlet side of the aftercooler is within specification, attach the pressure gauge to the gear oil cooler drain plug located on the outlet side and check for pressure drop across the gear oil cooler. If the pressure drop between the inlet side (1) and the outlet side (2) of the gear cooler is greater than the maximum specification, check for blockage in the gear cooler. Clean or replace if necessary.
Refer to Procedure 018-018 for Marine engine specifications.