Aftercooler Assembly C Series Page 10-2 Section 10 - Air Intake System - Group 10 Aftercooler Assembly (010-002) Initial Check Test NOTE: For marine seawater aftercooler only . Install pressure gauge, Part Number ST-1273, in the turbocharger boost pressure fitting in the elbow at the turbocharger outlet. Install another pressure gauge, Part Number ST- 1273, in the intake manifold on the outlet side of the aftercooler. Operate the engine at rated rpm and load. Record the readings on the two gauges. If the pressure differential is greater than the specification, inspect the aftercooler and associated piping for plugging. Clean or replace if necessary.
Aftercooler - Pressure Differential 380 mm Hg 15 in Hg