C Series Air Leaks, Air Intake and Exhaust Systems Section 10 - Air Intake System - Group 10 Page 10-7 Finishing Steps Install the high-pressure fuel lines. Refer to Procedure 006-051. Connect all of the charge air cooler hoses, if used. Refer to Procedure 010-027. Install the air crossover tube. Refer to Procedure 010-019. Connect the cold starting aid, if used. Refer to the OEM service manual. Air Leaks, Air Intake and Exhaust Systems (010-024) General Information Loose connections or cracks in the suction side of the intake pipe can allow debris to be ingested by the engine, causing rapid wear in the cylinders.
Leaks at the intake manifold, unsealed bolt holes, or manifold cover gasket allow dust and dirt to be ingested into naturally aspirated engines. Loose connections or cracks in the suction side of the intake pipe on turbocharged engines allow debris to be ingested into the turbocharger compressor and then forced into the engine. Debris drawn into the air suction side can damage the compressor blades, causing an imbalance resulting in bearing failure. NOTE: To verify a bearing failure or damaged compressor, remove the intake and exhaust piping and check for contact. The rotor assembly must rotate freely and must not be damaged.
Measurement of axial and radial clearance is described in this section.