C Series Turbocharger Section 10 - Air Intake System - Group 10 Page 10-17 With the feeler gauge in the same location, gently push the compressor wheel away from the compressor housing and measure the clearance between the compressor wheel and housing. Subtract the smaller clearance from the larger clearance. This is the radial bearing clearance. Radial Bearing Clearance mm in 0.30 MIN 0.012 0.46 MAX 0.018 Repeat the procedure on the turbine wheel. Replace the turbocharger if the radial bearing clearance does not meet specifications. See Remove and Install steps in this procedure. Leak Check Inspect the compressor intake and discharge for oil.
If oil is present in the compressor intake as well as in the discharge, check upstream in the turbocharger for the source of the oil. If oil is present only in the discharge side, install the air intake and CAC piping. Check for intake restriction. Refer to Procedure 010-031. If excessive intake restriction is not found, replace the turbocharger. See the Remove and Install steps in this procedure. NOTE: If the engine experiences a turbocharger failure or any other occasion where oil is put into the charge air system, the charge air system must be inspected and cleaned. Refer to Procedure 010-027.
Add 1 unit of fluorescent tracer, Part Number 3376891, to each 38 liters [10.0 gal] of engine lubricating oil. Operate the engine at low idle for 10 minutes.