Turbocharger C Series Page 10-16 Section 10 - Air Intake System - Group 10 Remove the exhaust pipe from the turbocharger. See the Remove step in this procedure. Inspect the turbine wheel for damage. Replace the turbocharger if damage is found. See the Remove and Install steps in this procedure. Axial Clearance Check Use dial depth gauge, Part Number ST-537. Push the rotor assembly away from the gauge. Set the gauge on zero. Push the rotor assembly toward the gauge and record the reading. Axial Clearance mm in 0.038 MIN 0.0015 0.093 MAX 0.0037 Replace the turbocharger if the clearance does not meet the specifications. See the Remove and Install steps in this procedure.
Radial Clearance Check Use a wire-type feeler gauge to measure the clearance between the compressor wheel and housing. Gently push the compressor wheel toward the compressor housing and gauge. Record the clearance.