C Series Turbocharger Section 10 - Air Intake System - Group 10 Page 10-15 Operate the engine at full throttle and rated rpm with maximum load. Record the data on the gauge or manometer. Inlet Air Restriction mm H 2 O in H 2 O 635 MAX 25 If restriction exceeds specifications, replace or clean the air filter element. Refer to the equipment manufacturer's instructions. Inspect the intake piping for damage. Refer to the equipment manufacturer's repair instructions. Remove the test equipment. Turbocharger (010-033) Initial Check Remove the intake pipe from the turbocharger. See the Remove step in this procedure. Inspect the turbocharger compressor impeller blades for damage.
Replace the turbocharger if damage is found. See the Remove and Install steps in this procedure. If the compressor impeller is damaged, inspect the intake piping and filter element for damage. Repair any damage before operating the engine.