C Series Turbocharger Axial Clearance Section 10 - Air Intake System - Group 10 Page 10-23 Lubricate the bearings by pouring 59 to 89 ml [2 to 3 oz] of clean 15W40 engine oil into the turbocharger oil supply line fitting. Rotate the turbine wheel to allow oil to enter the bearing housing. Install the turbocharger oil supply line. Refer to Procedure 010-046. Finishing Steps Install the intake manifold pressure supply line to the boost capsule, if equipped. Connect the charge air cooler hose. Refer to the OEM service manual. Install the air crossover, if equipped. Refer to Procedure 010-019. Operate the engine and check for leaks.
Turbocharger Axial Clearance (010-038) Measure Measure the turbocharger shaft end play; refer to the Turbocharger Manual, Bulletin 3810321. Measure radial clearance of the turbocharger shaft. Turbocharger Axial Clearance mm in 0.30 MIN 0.012 0.46 MAX 0.018 The turbocharger must be replaced if the clearances are beyond these limits. Refer to Procedure 010-033.