Cummins — 3666003

Intake Manifold Air Heater Speed Sensor C Series Page 10-48 Section 10 - Air Intake System - Group 10 2. Short Circuit Between Coils: Check the resistance between connectors (Pin A to Pin A and Pin B to Pin B) with a multimeter. The multimeter must show an open circuit (100k ohms or more). If fewer than 100k ohms are measured, there is a short circuit in the sensor. Replace the sensor. 3. Coil Resistance: Check the resistance between the pins of each connector (Pin A to Pin B). Install Use a barring gear, Part Number 3377371, to rotate the crankshaft so that a ring gear tooth is at the center of the hole for the engine speed sensor.

Insert the engine speed sensor and turn it until the end touches the ring gear tooth. Back off a half turn and tighten the locknut while holding the engine position sensor. Torque Value: 34 to 47 N•m [ 25 to 35 ft-lb ] Overtightening will damage the sensor. Resistance Specification First coil 750 to 1100 ohms Second coil 1100 to 1500 ohms