Cummins — 3666003

C Series Intake Manifold Air Heater Speed Sensor Section 10 - Air Intake System - Group 10 Page 10-47 Remove Disconnect the engine speed sensor from the engine wiring harness. Remove the sensor from the flywheel housing. Inspect for Reuse Inspect the engine speed sensor for debris, cracked or chipped potting, and damage from contact with the flywheel. Clean or replace the engine speed sensor if necessary. Test 1. Short Circuit to Ground: Measure the resistance of each connector (Pin A or B) of both circuits to ground (sensor body) with a multimeter. The multimeter must show an open circuit (100k ohms or more). If fewer than 100k ohms are measured, there is a short circuit to the sensor.

Replace the sensor.