Cummins — 3666003

C Series Air Compressor Section 12 - Compressed Air System - Group 12 Page 12-3 Install and tighten the air inlet and outlet connections. Torque Value: Inlet Connection 5 N•m [ 48 in-lb ] Outlet Connection 24 N•m [ 18 ft-lb ] Ѕ-NPT fitting in compressor cylinder head. NOTE: The torque value for the discharge line depends on the size and type of line. Refer to the OEM for the correct torque value. Close the wet tank draincock. Operate the engine and inspect for any air leaks. Air Compressor (012-014) Leak Test The external pressure tank used must meet SAE J10 and FMVSS121 standards, and have a safety pressure relief valve which opens between [150 to 175 psi].

Failure to use the proper pressure vessel and plumbing can result in property damage and serious personal injury. Air Compressor Diagnostic Test WARNING Park the vehicle. Use wheel chocks or an appropriate anti-roll device to stabilize the vehicle. Drain the vehicle air system. Remove the air discharge hose and air govenor signal hose from the air compressor. Install pipe plugs into the air compressor unloader signal ports. Plumb the air compressor discharge hose into an external pressure tank. The external pressure tank must be equipped with a pressure gauge and pressure relief valve. Make sure that the fittings are install with appropriate thread sealant and do not leak.

Start the engine and operate at rated engine speed. Verify that the air compressor will build pressure in the external tank. If air pressure fails to build in the pressure tank, the air compressor has malfunctioned. Refer to Procedure 012-013 in Section 12. NOTE: Once the external pressure tank pressure reaches 689 kPa [100 PSI], shut the engine down. Monitor the pressure gauge on the external tank for rapid leak down of the air pressure. If the air tank loses more than 138 kPa [20 PSI] in a 5 minute period, the pressure relief valve, intake valve, or exhaust valve has malfunctioned. The air compressor cylinder head intake and exhaust valves are not serviceable.

Replace the air compressor cylinder head. Refer to Procedure 012-007 in Section 12. NOTE: Do not cycle air accessories such as seats, doors, wipers, air bags, etc. If there is any noticeable decrease of the air gauge readings or the air dryer cycled during the 10 minute test, repair the leaks