C Series Air Governor (Air Compressor Pumps Continuously) Section 12 - Compressed Air System - Group 12 Page 12-11 Air Governor (Air Compressor Pumps Continuously) (012-018) Test Remove the accessory air lines from the air governor unloader port. NOTE: Do not disconnect the line from the air compressor unloader valve. Do not disconnect the reservoir air line from the air governor. Install pipe plugs in the air governor unloader ports where the accessory air lines were removed. Operate the engine to activate the air compressor. If the air compressor stops pumping (air pressure stops rising) at the governed air pressure, there is a leak in an accessory or an accessory air line.
Refer to the OEM's instructions for troubleshooting and repair instructions. If the air compressor does not stop pumping (air pressure continues to rise) at the governed air pressure, connect a regulated shop air pressure line to the air compressor unloader valve port. NOTE: Make sure the signal line from the air governor to the compressor unloader is not leaking. NOTE: Make sure the air pressure gauge is accurate and the supply line and fittings are in good condition before performing any air pressure checks. Use a master gauge of known accuracy to measure the air pressure gauge.