Cummins — 3666003

Air Governor (Air Compressor Pumps Continuously) C Series Page 12-12 Section 12 - Compressed Air System - Group 12 Apply 690 kPa [100 psi] air pressure to the unloader port. If the air compressor stops pumping (air pressure stops rising), the air governor is malfunctioning and must be repaired or replaced. Refer to the OEM's instructions. If the air compressor continues to pump (air pressure continues to rise), the unloader valve is malfunctioning and must be repaired or replaced. Remove the air compressor for repair; refer to Procedure 012-014. Remove the pipe plug from the governor port used for the accessory air line. Remove the regulated shop air.

Install and tighten the accessory air line. Connect the line between the compressor unloader valve and the air governor. Operate the engine and inspect for air leaks.