Cummins — 3666003

C Series Lubricating Oil System - Overview Section F - Familiarization Page F-13 Cylinder Head Gasket Coolant in the oil can also be caused by a damaged cylinder head gasket. Pressurize the cooling system to check for leaks. Remove the oil pan to locate internal leaks, if necessary; refer to Procedure 007-025. Cracked Cylinder Head A crack in the head from the water jacket to an oil passage or to the top rocker lever area will cause oil dilution. Pressurize the cooling system to 140 kPa [20 psi] and check for leaks. Cracked Cylinder Liner A cracked cylinder liner can leak coolant into the lubricating oil. Remove oil pan and look for coolant leaking from inside of liner bore. NOTE:

Air compressor leaks will produce the same symptoms; refer to Procedure 012-019 before concluding that the leak is from the cylinder liner. A crack in the cylinder block from an oil drilling or passage to the water jacket can cause oil dilution and can normally be found either as an external leak from a gasket (i.e., head gasket), or from the oil pickup tube with the oil pan off. Cracked Cylinder Block The cooling system must be pressurized to 140 kPa [20 psi] to detect leaks.