Cummins — 3666003

Lubricating Oil System - Overview C Series Page F-14 Section F - Familiarization Fuel Diluted Oil Fuel dilution can only come from three sources: 1. Fuel transfer pump 2. Fuel leaking over the rings 3. Injection pump internal wear. Fuel Transfer Pump NOTE: On nonautomotive engines, a worn or damaged seal around the plunger can allow fuel to leak into the oil pan. Automotive engines have a weep hole to allow the fuel to leak externally. Fuel Leaking by Piston Rings Incomplete combustion in the cylinders can result in unburned fuel draining into the oil pan. This condition can be caused by a leaking injector or reduced compression caused by inadequate piston ring sealing.

An increase in white exhaust smoke during the first start of the day is a symptom of an injector leaking. An injector leak will also cause the engine to run rough and have low power. Remove and replace leaking injectors; refer to Procedure 006-026. Refer to the Shop Manual, C Series Engines, Bulletin No. 3810476, for test and repair instructions.