C Series Starter Switch Section 13 - Electrical Equipment - Group 13 Page 13-7 Turn the starting motor switch to the OFF position. Remove the multimeter leads and connect the magnetic switch to the starting motor solenoid wire. Starter Switch (013-018) Test WARNING Make sure the starting motor switch is in the OFF position to prevent electrical shock and personal injury. Remove the wire connecting the starting motor switch to the magnetic switch (marked S or START) from the starting motor switch terminal. Connect the positive (+) lead of digital multimeter, Part Number 3377161, to the starting motor switch terminal and the negative (-) lead to a chassis or engine ground location. NOTE:
With the starting motor switch in the OFF position, there must not be voltage at the starting motor switch terminal. If the multimeter indicates voltage, the starting motor switch is malfunctioning and must be replaced. Turn the starting motor switch to the START position. The multimeter must indicate system voltage.