Cummins — 3666003

Starter Solenoid C Series Page 13-8 Section 13 - Electrical Equipment - Group 13 If there is no voltage: Turn the starting motor switch to the OFF position. Connect the multimeter positive lead to the starting motor switch terminal having a wire connecting the starting motor switch to the starting motor solenoid B terminal. Turn the starter switch to the START position. If the multimeter indicates system voltage at the starting motor switch input terminal, the starting motor switch is not the cause of the complaint. Inspect the wiring from the starting motor switch to the starting motor solenoid B terminal and from the starting motor solenoid to the battery from damaged or broken wires.

If the multimeter indicates no voltage, the switch is defective and must be replaced. Starter Solenoid (013-019) Initial Check Before troubleshooting the starting motor, make sure the battery terminals are not loose or corroded.