Cummins — 3666003

Starter Solenoid C Series Page 13-10 Section 13 - Electrical Equipment - Group 13 Voltage Check Set the digital multimeter, Part Number 3164488, to measure DC voltage. Connect the multimeter positive (+) lead to the starter solenoid positive cable terminal and the negative (-) lead to a chassis or engine ground location. The multimeter must show a voltage with the starter switch “OFF” to be normal. If the multimeter does not indicate a voltage, check the cable connecting the starter solenoid and battery for breaks. Also check for loose or corroded connections.

If the multimeter indicates a voltage, but the starter will not operate, check the wire connecting the starter solenoid to the starter switch for breaks. Also check for loose or corroded connections. Be sure to check for: Fuses Application engine shutoff systems. If the wire connecting the starter solenoid and starter switch is not loose or damaged, and the starter will not operate, remove the cable connecting the starter and starter solenoid from the solenoid terminal. Connect the multimeter positive (+) lead to the solenoid positive (+) terminal and the negative (-) lead to the chassis or an engine ground location.