Cummins — 3666003

Engine Testing (Chassis Dynamometer) C Series Page 14-2 Section 14 - Engine Testing - Group 14 Engine Testing (Chassis Dynamometer) (014-002) Setup The performance of an engine installed in on-highway vehicles can be tested on a chassis dynamometer. NOTE: Because of driveline efficiency and engine-driven accessories, the engine horsepower when measured at the rear wheels will be reduced by approximately: 20 percent for single-axle vehicles 25 percent for tandem-axle vehicles 35 percent for recreational vehicles. NOTE: These percentages are used for engine run-in only and are not to be used as absolute figures.

WARNING Follow all of the vehicle manufacturer's safety precautions before installing or operating a vehicle on a chassis dynamometer. Failure to do so can cause damage to the vehicle and/or harm personnel. CAUTION Low-profile tires are more sensitive to heat than bias ply tires. Excessive operating time at full load can damage the tires due to overheating. Check the tire manufacturer's recommendations for the maximum allowable chassis dynamometer operating time.