Cummins — 3666003

Engine Run-in (Engine Dynamometer) C Series Page 14-12 Section 14 - Engine Testing - Group 14 Do not crank the engine for more than 30 seconds. Excessive heat will damage the starting motor. CAUTION Crank the engine and observe the lubricating oil pressure when the engine starts. If the engine fails to start within 30 seconds, allow the starting motor to cool for 2 minutes before ranking the engine again. CAUTION If the lubricating oil pressure is not within specifications, shut off the engine immediately. Low lubricating oil pressure will cause engine damage. Engine lubricating oil pressure must be at least 70 kPa [10 psi] at 700 rpm.

Correct the problem if the lubricating oil pressure is not within specifications. Do not operate the engine at idle speed longer than specified during engine run-in. Excessive carbon formation will cause damage to the engine. CAUTION Operate the engine at approximately 700 rpm for 3 to 5 minutes. Listen for unusual noises; watch for coolant, fuel, and lubricating oil leaks; and check for correct engine operation in general. Repair all leaks or component problems before continuing the engine run-in.