C Series Engine Run-in (Engine Dynamometer) Section 14 - Engine Testing - Group 14 Page 14-13 Move the throttle to obtain 1,200 rpm engine speed, and set the test load to 25 percent of the rated load. Operate the engine at this speed and load level until the coolant temperature is 70° C [160° F]. Check all gauges and record the data. Do not proceed to the next step until a steady blowby reading is obtained. Open the throttle to the speed at which peak torque occurs, and adjust the dynamometer load to 50 percent of torque peak load. Operate the engine at this speed and load level for 2 minutes. Check all gauges and record the data.
Do not proceed to the next step until blowby is stable within specifications. With the engine speed remaining at torque peak rpm, increase the dynamometer load to 75 percent of torque peak load. Operate the engine at this speed and load level for 2 minutes. Check all gauges and record the data. Do not proceed to the next step until blowby is stable within specifications. Move the throttle lever to its fully opened position, and increase the dynamometer load until the engine speed is at torque peak rpm. Operate the engine at this speed and load level for 10 minutes or until the blowby becomes stable within specifications. Check all gauges and record the data.