Engine Run-in (Engine Dynamometer) C Series Page 14-14 Section 14 - Engine Testing - Group 14 Reduce the dynamometer load until the engine speed increases to the engine's rated rpm. Operate the engine at rated rpm for 5 minutes. Check all gauges and record the data. CAUTION Shutting off the engine immediately after operating at full load will damage the turbocharger and internal components. Always allow the engine to cool before shutting it off. Remove the dynamometer load completely, and operate the engine at 700 rpm for 3 to 5 minutes. This period will allow the turbocharger and other components to cool. Shut off the engine.
Engine Dynamometer Test - Performance Checking Make sure the air compressor is unloaded during the performance check. Apply regulated air pressure of 655 kPa [95 psi] to the air compressor unloader (1). The compressed air load in the accompanying illustration must be attached to the air compressor outlet (2).