Cummins — 3666003

C Series Engine Run-in (Engine Dynamometer) Section 14 - Engine Testing - Group 14 Page 14-15 Do not crank the engine for more than 30 seconds. Excessive heat will damage the starting motor. CAUTION Crank the engine and observe the oil pressure when the engine starts. If the engine fails to start within 30 seconds, allow the starting motor to cool for 2 minutes before cranking the engine again. CAUTION If the lubricating oil pressure is not within specifications, shut off the engine immediately. Low lubricating oil pressure will cause engine damage. Correct the problem if lubricating oil pressure is not within specifications.

Engine lubricating oil pressure must be at least 69 kPa [10 psi] at approximately 700 rpm. Make sure the engine is at operating temperature. Move the throttle lever to the "FULL OPEN'' position. Adjust the dynamometer load until the engine maintains the rated rpm. Allow the readings to stabilize. Read the horsepower. Check all the gauges, and record the readings. The horsepower reading will not be accurate if the lubricating oil temperature and fuel temperature are not within specifications. Lubricating Oil Temperature °C °F 90 MAX 190 Fuel Temperature °C °F 32 MAX 90 Check all gauges and record the data.