Crankcase Blowby, Measure C Series Page 14-20 Section 14 - Engine Testing - Group 14 The following chart contains general blowby specifications for MidRange engines. Due to the wide variety of engine types, configurations, and ratings, these specifications are intended to only be used as a guide to help identify if a problem exists. These specifications are not intended to be used as engine condemnation limits. NOTE: If internal engine damage is suspected to be the cause of the excessive blowby condition, other steps can be taken to confirm this. Measuring blowby must only be considered when confirming engine break-in after a rebuild or if another symptom is present.
These symptoms can include: Excessive carryover (oil out of the crankcase breather tube) High crankcase pressure (for engines equipped with a crankcase pressure sensor) Low power Oil consumption Exhaust smoke. If no other symptom is present, blowby measurements need not be taken.
Blowby Conversion Table (7.67-mm [0.302-in] orifice, Blowby Tool, Part Number 3822566) mm [in] of H O 2 Liter [cfm] per Minute 228.6 [9] 172 [6.074] 254 [10] 180 [6.357] 279.4 [11] 187 [6.604] 304.8 [12] 193 [6.816] 330.2 [13] 200 [7.063] 355.6 [14] 206 [7.275] 381 [15] 211 [7.451] 406.4 [16] 217 [7.663] 431.8 [17] 222 [7.840] 457.2 [18] 226 [7.981] 482.6 [19] 229 [8.087] 508 [20] 235 [8.299] 533.4 [21] 239 [8.440] 558.8 [22] 242 [8.546] 584.2 [23] 246 [8.687] 609.6 [24] 248 [8.758]