Crankcase Blowby, Measure C Series Page 14-28 Section 14 - Engine Testing - Group 14 Use a suitable fitting to plug the crankcase breather tube. Engine Blowby Contribution: Operate the engine at rated speed and under load by: For engine run-in, a chassis dynamometer or engine dynamometer. For engine testing, a chassis dynamometer or engine dynamometer. A stall speed test (for engines equipped with automatic transmissions only ). When measuring blowby and there is an excessive amount of oil coming out of the breather tube, the quantity of oil can affect the blowby measurement. CAUTION Operate the engine at rated rpm and full load until a steady reading is obtained. NOTE:
When measuring blowby, the value can “spike” initially as the engine reaches peak power and rated speed. Wait for the blowby measurement to stabilize before taking a reading. NOTE: For engine run-in, if a sudden increase in blowby occurs, or if blowby exceeds the maximum allowable limit during any run-in step, return to the previous step and continue the run-in. If blowby does not reach an acceptable level, discontinue the run-in and determine the cause. Record the steady blowby measurement. Remove the engine blowby service tool and the water manometer, pressure gauge, or transducer, if the blowby is within specification.