Crankcase Blowby, Measure C Series Page 14-34 Section 14 - Engine Testing - Group 14 Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING Air Compressor Blowby Contribution: With the engine blowby service tool and the water manometer, pressure gauge, or transducer still installed, isolate the air compressor, if equipped, to determine if there is internal damage to the air compressor contributing to high engine crankcase pressure. The air compressor can be isolated by unloading the air compressor.
With the engine shut off, bleed the vehicle's air system down by opening the drain cock on the wet tank to release compressed air from the system. NOTE: The air compressor governor/unloader location can vary on each engine application. The air governor/ unloader can be air compressor mounted or chassis mounted. Disconnect the air signal line from the air compressor governor/unloader air signal port. Disconnect the air compressor discharge line and air intake hose from the air compressor. NOTE: On turbocharged air compressors, make sure to plug the air intake hose connected to the engine intake manifold or the engine will not reach full power during test.
To unload the air compressor, determine the pressure needed at the governor/unloader air signal port to start and stop the air compressor from pumping. NOTE: Typical 621 kPa [90 psi] of air pressure is the set point between starting and stopping of the air compressor pumping. Refer to the OEM service manual. Connect a regulated shop air pressure line, with pressure gauge, to the air compressor governor/unloader air signal port. NOTE: When performing the test, make sure that the air system pressure does not exceed the manufacturer's maximum allowable pressure.
Run the engine and increase the signal pressure to the air governor/unloader to determine when the air compressor will stop pumping (system pressure stops rising at this point). Record the signal line pressure. Reduce the signal pressure to determine when system pressure starts the air compressor pumping again (system pressure will begin to rise again at this point). Record the signal line pressure. NOTE: Allow the air compressor to pump long enough to build enough pressure in the system to release and operate the air brakes.