Cummins — 3666003

C Series Crankcase Blowby, Measure Section 14 - Engine Testing - Group 14 Page 14-37 Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. WARNING With the engine shut off, bleed the vehicle's air system down by opening the drain cock on the wet tank to release compressed air from the system. Disconnect the regulated shop air pressure line, with pressure gauge, from the air compressor governor/ unloader air signal port. Connect the air signal line. Refer to the OEM service manual. Remove the engine blowby service tool and water manometer or pressure gauge if the blowby is within specification. NOTE:

On turbocharged air compressors, make sure to remove the plug previously installed in the air intake hose connected to the engine intake manifold. Connect the air compressor discharge line and air intake hose from the air compressor. Exhaust Brake Blowby Contribution: NOTE: Not all vehicles are equipped with an exhaust brake. With the engine blowby service tool and the water manometer, pressure gauge, or transducer still installed, measure blowby pressure during exhaust brake operation, if equipped. Operate the vehicle going down a long inclined road such as a highway or interstate off ramp.

Begin exhaust brake operation at rated engine speed while measuring blowby pressure during exhaust brake operation.