Crankcase Blowby, Measure C Series Page 14-38 Section 14 - Engine Testing - Group 14 Also, measure exhaust back pressure during exhaust brake operation. Operate the engine until a steady reading is obtained. NOTE: When measuring blowby, the value can “spike” initially as the engine reaches peak power and rated speed. Wait for the blowby measurement to stabilize before taking a reading. If blowby pressure is above specification during exhaust brake operation and exhaust back pressure is above specification, repair or replace the exhaust brake. See the manufacturer's instructions.
If the blowby pressure is above specification during exhaust brake operation and the exhaust back pressure is within specification, check the turbocharger blowby contribution. Reference the turbocharger oil drain isolation step previously in this procedure. Remove the engine blowby service tool and the water manometer, pressure gauge, or transducer. Remove the pressure gauge used to measure exhaust back pressure during exhaust brake operation. Install a plug in the test port. Base engine components can also be contributing factors of increased crankcase blowby and higher than normal crankcase pressure.
Reference the Crankcase Gases (Blowby) Excessive troubleshooting symptom tree in Section TS of the appropriate engine service manual to evaluate the remaining possible causes for increased blowby and higher than normal crankcase pressure. The following are listed as possible base engine component causes: Base Engine Component Blowby Contribution: