Cummins — 3666003

C Series Engine Compression Section 14 - Engine Testing - Group 14 Page 14-43 Engine Compression (014-012) Measure It is very time-consuming and expensive to begin removing internal engine components to diagnose failures. A compression gauge, Part Number 3164627, and adapter, Part Number 3164840, can be used as an aid to check for proper functioning of the following components: 1. Piston ring sealing 2. Intake and exhaust valve sealing 3. Cylinder head gasket sealing 4. Cylinder head cracked Refer to the appropriate procedure in this section for replacement of failed components. NOTE:

Due to variables such as starter and battery conditions that affect engine cranking speed, it is difficult to establish an absolute value for compression pressure; however, the following values can be used as guidelines: New engine (cranking speed at 250 rpm) 2413 kPa [350 psi] Used engine (cranking speed at 250 rpm) 2068 kPa [300 psi] It is recommended that the compression pressure be checked on all cylinders and then compared. All cylinders should be within 690 kPa [100 psi] of each other. If the compression is low but can be increased significantly by squirting oil into the cylinder, the cause of low compression is inadequate sealing between the rings and the cylinder walls.

Refer to procedure 007-013 for piston ring replacement. Piston Ring Sealing