C Series Flywheel Section 16 - Mounting Adaptations - Group 16 Page 16-7 Flywheel Face Runout Install the contact tip of the indicator against the flywheel face, as close to the outside diameter as possible, to inspect the face (1) runout. NOTE: Push the flywheel forward to remove the crankshaft end clearance. Adjust the dial on the indicator until the needle points to zero. Use the barring tool, Part Number 3824591, to rotate the crankshaft one complete revolution. Measure the flywheel runout at four equal points on the flywheel. NOTE: The flywheel must be pushed toward the front of the engine to remove the crankshaft end clearance each time a point is measured.
The total indicator reading (TIR) must not exceed the following specifications: Flywheel Radius (A) Maximum of Flywheel Face mm in mm in 203 8 0.203 0.008 254 10 0.254 0.010 305 12 0.305 0.012 356 14 0.356 0.014 406 16 0.406 0.016 If the flywheel face runout is not within specifications, remove the flywheel. Check for nicks, burrs, or foreign material between the flywheel mounting surface and the crankshaft flange.