Cummins — 3666003

Flywheel C Series Page 16-8 Section 16 - Mounting Adaptations - Group 16 Install the clutch discs, pressure plate, transmission, and driveline (if equipped) in reverse order of removal. Refer to the manufacturer's instructions. NOTE: Align the universal joints on each end of the driveshaft to prevent vibration. Install NOTE: Use a new pilot bearing when installing a new or rebuilt clutch. Use a mandrel and hammer to remove the pilot bearing. Use a Scotch-Brite™ 7448, or equivalent, to clean the pilot bore. Use a mandrel and hammer to install the pilot bearing. NOTE: The pilot bearing must be installed evenly with the pilot bore surface.

Install two M12 x 1.25 x 90-mm guide pins into the crankshaft flange 180 degrees apart. NOTE: If a clutch is used in the equipment, the threads in the clutch pressure plate mounting capscrew holes can be metric or standard. Be sure to use the correct capscrews. Determine the capscrew thread design and size, and install two t-handles into the flywheel (at points 1 and 2).