Cummins — 3666003

Flywheel Housing C Series Page 16-12 Section 16 - Mounting Adaptations - Group 16 Inspect for Reuse Inspect the flywheel housing for cracks, especially in the bolt pattern area. Inspect all surfaces for nicks, burrs, or cracks. Use fine crocus cloth to remove small nicks and burrs. Inspect for damaged threads commonly caused by cross- threaded capscrews or installing an incorrect capscrew. Helicoils are available to repair damaged threads. Measure Bore Alignment Attach the dial indicator gauge, Part No. 3376050, to the crankshaft. The dial indicator can be mounted by any method that holds the extension bar of the indicator rigid, so it does not sag.

If the bar sags or the indicator slips, the readings obtained will not be accurate. Position the indicator in the six-o'clock position, and zero the gauge. Slowly rotate the crankshaft. Record the readings obtained at the nine-o'clock, twelve-o'clock, and three- o'clock positions as [a], [b], and [c] in the concentricity work sheet. Recheck zero at the six-o'clock position. The values for (a), (b), and (c) could be positive or negative. Refer to the accompanying figure to determine the correct sign when recording these values.