C Series Flywheel Housing Section 16 - Mounting Adaptations - Group 16 Page 16-13 Do not force the crankshaft beyond the point where the bearing clearance has been removed. Do not pry against the flywheel housing. These actions could cause false bearing clearance readings. CAUTION Rotate the crankshaft until the dial indicator is at the twelve o'clock position and zero the gauge. Using a pry bar, raise the rear of the crankshaft to its upper limit. Record the value as (d) in the concentricity work sheet. This is the vertical bearing clearance adjustment and will always be positive.
Using the concentricity work sheet, determine the values for the “total vertical” and “total horizontal” values. The total horizontal is equal to the nine-o'clock reading (a), minus the three-o'clock reading (c). The total vertical is equal to the twelve-o'clock reading (b), plus the bearing clearance (d). Example: Six o'clock = ref = 0, Nine o'clock = (a) = 0.004, Twelve o'clock = (b) = 0.003, Three o'clock = (c) = -0.002 Using the work sheet and the numbers from the example, the total horizontal value equals 0.006 and the total vertical value equals 0.005. Mark the total horizontal value on the horizontal side of the chart and the total vertical on the vertical side of the chart.
Using a straightedge, find the intersection point of the total horizontal and total vertical values. The intersection point must fall within the shaded area for the flywheel housing concentricity to be within specification. Using the total horizontal and total vertical values from the previous example, the intersection point falls within the shaded area. Therefore, the flywheel housing concentricity is within specification. If the intersection point falls outside the shaded area, the ring dowels must be removed and the housing repositioned. NOTE: The ring dowels are not required to maintain concentricity of the housing; the clamping force of the capscrews holds the housing in place.
After the ring dowels are discarded, install the flywheel housing on the engine. To position the housing, tighten the capscrews enough to hold the flywheel housing in place, but loose enough to allow small movement when struck lightly with a mallet. Recheck the concentricity. When concentricity is within specification, tighten the capscrews to the specified torque value.