Flywheel Housing C Series Page 16-14 Section 16 - Mounting Adaptations - Group 16 The dial indicator tip must not enter the capscrew holes, or the gauge will be damaged. CAUTION Face Alignment Install the dial indicator gauge, Part No. 3376050, as illustrated. NOTE: The extension bar for the indicator must be rigid for an accurate reading. It must not sag. Position the indicator at the twelve-o'clock position. Adjust the dial until the needle points to zero. Slowly rotate the crankshaft. Record the readings at the three-o'clock, six-o'clock, and nine-o'clock positions. NOTE:
The crankshaft must be pushed toward the front of the engine to remove the crankshaft end clearance each time a position is measured. Continue to rotate the crankshaft until the indicator is at the twelve-o'clock position. Check the indicator to make sure the needle points to zero. If it does not , the readings will be incorrect. Determine the total indicator reading (TIR). Example: mm in 12 o'clock 0.00 0.000 3 o'clock +0.08 +0.003 6 o'clock -0.05 -0.002 9 o'clock +0.08 +0.003 Equals TIR 0.13 0.005