Cummins — 3666003

Flywheel Housing C Series Page 16-16 Section 16 - Mounting Adaptations - Group 16 Inspect the rear face of the cylinder block and flywheel housing mounting surface for cleanliness and raised nicks or burrs. Install the flywheel housing over the two ring dowels. NOTE: Be sure the sealing ring is not damaged during installation. Tighten the flywheel housing capscrews in the sequence shown. Torque Value: 77 N•m [ 57 ft-lb ] Wet Clutch Application Perform all the steps in the procedure for dry clutch installation, in addition to the following: Coat the flywheel housing drain plug with pipe sealant, and install in the hole in the bottom of the flywheel housing. Tighten the plug.

Refer to the pipe plug torque values in Section 17 for different plug sizes. Install the plastic plug in the tachometer drive access hole.