Cummins — 3666003

C Series Flywheel Housing Section 16 - Mounting Adaptations - Group 16 Page 16-17 Install the access plate and new gasket. Install the capscrews and tighten. Torque Value: 24 N•m [ 18 ft-lb ] WARNING When using a steam cleaner, wear safety glasses or a face shield, as well as protective clothing. Hot steam can cause serious personal injury. When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to avoid personal injury. WARNING Thoroughly clean the flywheel housing and cylinder block mating surfaces. These surfaces must be clean of oil and debris. NOTE:

The capscrew holes on the mounting pads are drilled through. Coat set screws with Loctite 277 and install into holes. Set Screw Installation Depth (Flywheel Housing) mm in 3.00 MAX 0.118 Apply a continuous bead of Three-Bond™ around all capscrew holes on the mounting surface of the flywheel housing.