Cummins — 3666003

C Series Flywheel Housing, REPTO Section 16 - Mounting Adaptations - Group 16 Page 16-25 With the housing positioned so the cylinder block mating surface is down, use a hammer and brass punch to drive the bearing outer races out of the output shaft housing bore. Support the housing in a press with the cylinder block mating surface down. With a long mandrel, press out the idler shaft bushing. Remove and discard o-ring. NOTE: Save the original shims for rebuild purposes, to set the proper end clearance on the output shaft and bearing assembly. Use a hammer and brass drift to remove the two bearing outer races from the bore of the idler gear. Discard the outer races.

Remove the large spacer ring from the center groove of the gear. Discard the spacer ring. Clean WARNING When using a steam cleaner, wear safety glasses or a face shield, as well as protective clothing. Hot steam can cause serious personal injury. Use a steam cleaner to clean all areas of the idler gear.