Cummins — 3666003

C Series Flywheel Housing, REPTO Section 16 - Mounting Adaptations - Group 16 Page 16-27 Closely inspect the bore, the side faces and the teeth of the idler gear. Replace the gear if there are cracks, discoloration from excessive heat or other damage. Assemble Install a new o-ring on the idler shaft bushing. Use Lubriplate™ 105 to lubricate the o-ring. Support the housing evenly with the engine mating surface up. Press the new bushing into the housing until it is below the surface of the cylinder block mating surface. Use Lubriplate™ 105 to lubricate the larger bearing race. Use the larger end of driver, Part Number 3823893, to press the bearing race to the shoulder in the housing.