Flywheel Housing, REPTO C Series Page 16-28 Section 16 - Mounting Adaptations - Group 16 Turn the housing over and support evenly in the press. Use Lubriplate™ 105 to lubricate the smaller bearing race. Use the smaller end of driver, Part Number 3823893, to press the bearing race to the shoulder in the housing. Use Lubriplate™ 105 to lubricate the output shaft and larger bearing. Install the larger bearing onto the output shaft. Position the housing on the table so the cylinder block mating surface is up. Install the output shaft assembly into the housing. The correct end clearance (rolling resistance) is determined by the number and thickness of shims used between the two bearings.
When the shim thickness is increased, there is more shaft end clearance and less rolling resistance. When the shim thickness is decreased, there is less shaft end clearance and more rolling resistance.