Cummins — 3666003

C Series Flywheel Housing, REPTO Section 16 - Mounting Adaptations - Group 16 Page 16-29 Turn the housing over with engine mating surface down, while holding the output shaft and gear in place. NOTE: If the original thickness of shims is not available for reuse, begining thickness of 1.47 mm [0.058 in] can be used as a starting point. Install the original thickness of shims. Use Lubriplate™ 105 to lubricate the smaller bearing. Install the smaller bearing onto the shaft. Temporarily install the output flange, before installing the oil seal. Use clean 15W-40 oil to lubricate the splines. Install the flat washer and capscrew.

Use the gear locking tool, Part Numnber 3823891, to hold the output shaft while tightening the capscrew. Torque Value: 205 N•m [ 150 ft-lb ]